Hello Guest it is May 25, 2025, 02:25:48 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Jog Speed  (Read 3762 times)

0 Members and 2 Guests are viewing this topic.

Offline rrc1962

*
  • 673 673
Jog Speed
« on: May 18, 2017, 09:51:29 PM »
Is there a way to slow the jog speed down on just one axis?  I need the rapid speed where it is on all axes, but jog speed on the Z axis needs to be 50%.  X and Y needs to stay at 100%. 
Logged

Offline joeaverage

*
  • 7,604 7,604
Re: Jog Speed
« Reply #1 on: May 19, 2017, 03:21:32 PM »
Hi,
I don't know for sure but
Quote
rc = mc.mcJogSetRate(
      number mInst,
      number axisId,
      number percent)
suggests that the jog rate is assigned per axis.

Craig
Logged
'I enjoy sex at 73.....I live at 71 so its not too far to walk.'

Offline DazTheGas

*
  • 778 778
  • DazTheGas
Re: Jog Speed
« Reply #2 on: May 23, 2017, 03:11:52 PM »
About the best way is to use the mc.mcJogSetRate as Craig mentioned, this could be done in the PLC script by getting the value of the slider and then setting the axis to what you require using a bit of maths ;-)

DazTheGas
Logged
New For 2022 - Instagram: dazthegas
Pages: 1   Go Up
« previous next »