Hello Guest it is December 15, 2019, 06:08:18 PM

Author Topic: Support synchronous with motion commands M10Px/M11Px for Mach3  (Read 2070 times)

0 Members and 1 Guest are viewing this topic.

Hello!
Does the HiCON INTEGRA controller support synchronous with motion commands M10P(output number)/M11P(output number) for Mach3 and M62 P(output number)/M63 P(output number) for Mach4?
Thank you!
--Andrew
Re: Support synchronous with motion commands M10Px/M11Px for Mach3
« Reply #1 on: April 09, 2017, 12:53:15 PM »
hi shad71,

HiCON Integra supports Mach4 sync outputs M62/M63.  Sorry no support for Mach3 M10/M11.

regards

Rufi
VitalSys
Re: Support synchronous with motion commands M10Px/M11Px for Mach3
« Reply #2 on: April 09, 2017, 03:06:13 PM »
Thank you Rufi.
--Andrew