Just gave that a try still didn't work ran a gnd form the gnd on enternal board to gnd on pokeys no go..

I did test my second board with just pokeys power and it worked so not a wiring problem...

Thanks gary

got it to work had to use the same power supply running the pokeys ended up putting a voltage regulator
to drop the voltage to from 12v to 5v on my board and it worked..

One little tip there for the pull up.

Take +5v from one of the axis output pin9 as most of you likely wont use all 8 axis.

I have now done some mails forth and back with Polabs, because of probe failures.. And i got a patch from them today that seems to have fixed the probe problem, they have also innplemented a security that stops motion if probe fails