Hello Guest it is January 25, 2020, 01:02:50 AM

Author Topic: Mach3 Leadshine MX4660 - Reconfiguration estop  (Read 1984 times)

0 Members and 1 Guest are viewing this topic.

Mach3 Leadshine MX4660 - Reconfiguration estop
« on: February 06, 2017, 11:34:16 AM »
Hi everyone, I have a Gryphon CNC and it was working great. I was using last Friday night and when I came back on Saturday I got this message "reconfiguration estop" and basically the machine is not working now.

I'll already check the power and everything is on so I think it's something related with the ports and pins configuration.

Any help or advice?

Offline Tweakie.CNC

  • *
  •  8,105 8,105
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Mach3 Leadshine MX4660 - Reconfiguration estop
« Reply #1 on: February 07, 2017, 05:08:22 AM »
I am assuming you cannot get Mach3 out of Reset…

Check your actual EStop switch to make sure it is reset (closed circuit) and that it is connected correctly.
Try changing the Active State for EStop in Config. / Ports & Pins / Input Signals.


Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.