Where I am at right now after connecting my computer and UC100 Pendant to my Gecko G50 is as follows.
Before I connect the UC100 Pendant I have a Green Light on the G540 until I reset my E-Stop.
I have my axis setup as follows X-axis Step 2, Dir 3; Y-axis Step 4, Dir 5; Z-axis Step 6, Dir 7 and A-axis Step 8, Dir 9 Slaved to the X axis and these are all on Port 1.
I'm beginning to think that my E-Stop is wired incorrectly for starters. Its wired Diagonally across the Inputs at the moment.
On the Diagnostic Page I have a Red Signal in I/O Monitor on 3,7,9 and Idle In UCCNC and in Mach3 there are No Red Lights showing.
Regardless as to whether or not I'm using UCCNC or Mach 3, I can get Zero Movement.
At this point I have a $6000.00 Boat Anchor instead of an Openbuilds OX CNC Router.
Does anyone have any idea as to what I am doing wrong?