I've done a lot of searching on this, but cant find a straight answer.
Does CSS work with FPR?
I cant get it to. I have to use FPI. Is this right?
I found a lot about how to use CSS, but not a lot about the feeds.
I'm cutting 6061 aluminum at 600css with a DOC of .1", and a feed of 10 to 12 IPM rough, and 6 IPM finnish.
It's working, but isnt it wrong, because of the diameter changing size?
Shouldn't it be FPR so the relation of cutting feed matches the speed?
How do others set their feeds for CSS?
I have the latest Licensed Ver. of Mach3 on a 2016 Shopmaster, using the Lathe.
Thanks