Thanks for the reply Chaoticone.
I just noticed you responded. Thank you.
I just double checked my steps per unit in Mach configuration. 10,000 Steps per unit. on all 3 of my motors 0,1,2 X,Y,Z
My motors are 200 step per rotation
My Gecko 540 is supposedly 10 microsteps fixed (so I am under the impression of)
My lead screw is 5 TPI (Inches)
So 200 * 10 * 5 = 10,000.
so that should give me 10,000 steps per inch or 1 microstep should be .0001
Does that sound right?
I didn't see any other adjustments for steps in my PMDX plug-in. (just so I don't over look anything here)
Am I on the same page as you? I'm a little green remember.
Thanks again
Todd K.