Hi DazTheGas,
I have to say I was pretty excited to get the Spin OVR happening, thanks again for you very impressive help.
All grown up and I still get that sinking feeling when things don’t quite go as planned. Two days now of…. Hmmm what if I try this or that or this..etc..
I think I must be filling in one of the options incorrectly as the Spin OVR slider in Mach 4 is stuck hard to the bottom. There are no errors when I run the Screen Load or PLC scrips. Actually there is a nagging little error in the PLC, but that has been there since day one.
Firstly, the name of my controller, I know this should be obvious to me, but do you mean the PoKeys, the ESS or the screen set? I have tried all three with no success.
I noticed that on your video, the name of the Screen Set is “machduino” which matched what you have in the table, however there are capitols in that line of code. “MachDuino”. So perhaps your Arduino is called machduino. Confussion. I am using screen set wx4.
The other thing is the name of the register. I assume that’s the name of the input when you look in the Register Diagnostics in Mach, which in my case is “Analog pin 42”. So I think I got that right.
Like I said, no errors show up, but that slider sucker won’t move. Any thoughts DTG? Sorry to harass on a Sunday.
Craig. (CRS)