Hi all,
i have big problem or i dont understand th manual.
I use the Pokeys57CNC on a combi lathe/mill.
The axis x, y and z works perfect on the mill, but on the lathe i will be deactivated the z-axis from the mill and change the y-axis from the table to the z-axis.
If i use my old lpt interface, i could change the pins in the port&pin setup-->Motorsettings, but the 57CNC didn't use pins.
The stepper driver are connected to motor port1, motor port2 and motor port3.
I hope somebody can help. Sorry for my bad english.
Thanks