Hello Guest it is September 21, 2023, 07:20:39 PM

Author Topic: Interpolating holes  (Read 2435 times)

0 Members and 1 Guest are viewing this topic.

Interpolating holes
« on: June 03, 2007, 02:00:13 PM »
   I would like to know if any one has experience with this problem? I am using MasterCam9.1, with the MasterCam/Mach3 post processor. I am interpolating some holes, but my machine will only make the arch on and off move. I have the holes programmed for center point with a 25% arch on and off, and I have selected enter and exit point setting. In verify, and back plot, everything looks good.


Online Graham Waterworth

  • *
  •  2,621 2,621
  • Yorkshire Dales, England
    • View Profile
Re: Interpolating holes
« Reply #1 on: June 04, 2007, 01:34:42 AM »
Post your code and the hole positions and sizes.

Without engineers the world stops