This is what i have....
CSMIO-Ip/A with spare analogue input 0-10v
VFD with analogue output programmed to show motor power in kW ranging from 0 to 150% as a 0-10v signal
Mach3
What i was thinking of is...
Adding a DRO to the screen that shows spindle power, either as kW or as % from 0 to 100% etc
Not important - just a bell or whistle but you know how it goes
So, is this possible? I am unsure as to the method of connecting the input signal to the DRO, the electrical side seems pretty well matched so thats easy.
Maybe a brain?