More weird tangential issues with Mach3.
I've got tangential working mostly as it should on an ultrasonic blade cutting system, with one big issue and a couple of smaller ones. The big problem happens when I load a new tap file and start the job. Even though tangential mode is toggled, the job doesn't run in tangential mode. However, after I hit stop, rewind the job, go back to zero, and restart the job, then tangential mode runs correctly. Anybody have any ideas for this?
One of the smaller issues is a very long pause (almost 2 seconds) after a rapid move before the head drops to the table surface and starts cutting. There are no G4 commands in the job file so I'm guessing it's some weird Mach3 or tangential issue.