Thanks for your reply, I have read the manualseveral times and that is why I think something is not right but not sure what. The download went well my test run with the Road Runner
G-Code went well. When I test my arrow keys my axis move in the program. However I'm not getting movement on my stepper motors. So I tested my port pins in the back of my computer. As I said my entire top row 1-13 are hot with 5V my bottom pins are 25-16 are 00 and pins 17-14 are 5V (I had the bottom row info reversed in my first post.)
So see if I understood, pins 1-9 are output, pins 2-7 are XYZ outputs these should only have voltage when the corresponding arrows are pressed. Pins 10-13 are input, The input should read 00 since there are no signals being sent from the cnc board back to the computer. My 10 pin is my E-Stop. Pins 25-18 are common and should read 00. 17-16 are output 15 input and 14 output. Am I correct ??