Ok, I see that lots of you are reading this but not getting much response.
So I have the Mach 3 Turn program turned on; I have the all the output signals the same as in Mach 3 Mill. The machine does not come "on line" when I click the reset button. Then after many trials I get a screen message that says "Your Reset command is failing due to an external influence. Either your reset mutton is ON, or your limit switches are active." the dialog goes on the change the Active Low on the Motor outputs. So I did but it didn't change anything. The machine still doesn't come on line.
Here is my question. Do I have to have the limit switches installed and up and working for me to use Mach 3 Turn?
I do not have to in Mach 3 Mill, it runs just fine without the limit switches installed, (next part of my project CNC is to get limit switches).
Thanks for any advice you can give,
Cary