I've got a Galil DMC1820 motion controller and the computer that ran it before has died so I'm trying to get this thing setup in Mach3 on a new computer.
It's run into a ICM-1900 which breaks out all the controls and pushes it out to the XY table which is run by a MCG Brush type servo amplifier model DMC 12D.
When power is on the controller holds the servo position so that you cannot move it so I know everything is "wired" correctly, but no matter what I do with mach3 I can't figure out how to get anything to turn.
The Galil plugin has been used, the computer recognizes the PCI card, and Galil drivers are installed. The card has been selected in Mach3, along with the index checkboxes. I do not know how to configure the motors as none of the "pins" are the same as in the ICM-1900. Most of the pins are in the ~80 range.
Any assistance would be appreciated. I'm running Mach3 on windows XP with the demo program. It is just controlling an XY table for a laser so I am using the plasma module.
Thanks!