Hello Guest it is November 27, 2021, 01:28:33 AM

Author Topic: bobcad 2007 mach 3 milll available  (Read 2936 times)

0 Members and 1 Guest are viewing this topic.

bobcad 2007 mach 3 milll available
« on: May 18, 2007, 07:25:49 PM »
Bobcad has released the Mach 3 post for v22.

(if this post shows up twice, it's because my computer had a spasm.)
Re: bobcad 2007 mach 3 milll available
« Reply #1 on: May 25, 2007, 11:32:07 PM »
Mach 2 should be posted by the end of next week. I was speaking to Glen at Bobcad support today and he said he will get to it. It will be just about the same as for V21 except when you set spindle direction it will also ask for rpm and a rapid point.