Hello Guest it is March 28, 2024, 12:18:30 PM

Author Topic: Mach3 need one more input for Pressure sensor?  (Read 7015 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Mach3 need one more input for Pressure sensor?
« Reply #20 on: April 16, 2016, 05:59:58 PM »
Ok which brain is it you are using, there are 3 that are enabled
OP78LED
ModIOMPG
PSI11

I presume it is the last one?
Hood

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Mach3 need one more input for Pressure sensor?
« Reply #21 on: April 16, 2016, 06:11:26 PM »
The brain has an issue, not sure exactly what but I deleted all the steps in it and redid and saved, then reloaded and it works fine.
Hood
Re: Mach3 need one more input for Pressure sensor?
« Reply #22 on: April 16, 2016, 06:15:37 PM »
Hood yes the last one is the brain that I am using.  I will try to delete the brain and then start over if thats what you did and it works.

Thanks for sharing your knowledge!

Jeff
Re: Mach3 need one more input for Pressure sensor?
« Reply #23 on: April 16, 2016, 06:16:09 PM »
Can you show me what the brain looks like that you did?
Re: Mach3 need one more input for Pressure sensor?
« Reply #24 on: April 16, 2016, 06:16:28 PM »
Maybe I did something to the brain when i was making it.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Mach3 need one more input for Pressure sensor?
« Reply #25 on: April 16, 2016, 06:20:24 PM »
Here is the brain.
I just deleted the steps in it and started again rather than totally deleting the brain, same difference I suppose.
Re: Mach3 need one more input for Pressure sensor?
« Reply #26 on: April 16, 2016, 07:00:08 PM »
Hood Thank You so much for your time I will give it a shot!

Jeff
Re: Mach3 need one more input for Pressure sensor?
« Reply #27 on: April 16, 2016, 07:16:38 PM »
Hood you are not going to believe this but I had it right all along from when you first showed me.  In the Inputs ports and pins I had the wrong pin!!!!  I had 3-7 and works when I have the right port and pin 3-8!!!  Well I feel stupid!

Thanks for the help