Hello Guest it is November 20, 2019, 12:04:04 AM

Author Topic: smooth stepper  (Read 2851 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  8,003 8,003
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: smooth stepper
« Reply #10 on: March 17, 2016, 03:44:30 AM »
if i was to go smooth stepper i could use more than one breakout bored for auto tool change and other stuff 

Yes.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline ozzey

*
  •  44 44
    • View Profile
Re: smooth stepper
« Reply #11 on: March 17, 2016, 05:11:34 AM »
thanks thats a big help

Offline Tweakie.CNC

*
  • *
  •  8,003 8,003
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: smooth stepper
« Reply #12 on: March 17, 2016, 06:07:08 AM »
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline olf20

*
  •  318 318
    • View Profile
Re: smooth stepper
« Reply #13 on: March 17, 2016, 07:22:37 AM »
Thats what I used is the c25. Nice to attach to the ESS
directly. One cable from the ESS to the PMDX.
Again it just worked for me when I was putting
my system back together.
olf20 / Bob
Mach3, Atlas Knee Mill, 4th Axis, VcarvePro, ESS, Super PID.
Been Heating with corn since 1998

Offline ozzey

*
  •  44 44
    • View Profile
Re: smooth stepper
« Reply #14 on: March 17, 2016, 07:56:23 AM »
im just useing a cheap Chinese breakout board $ 7.50 it works good   but the old PCs  are getting hard to get and unreliable would like to get a new PC