Hi all,
I have registered a Galil card (DMC 18x0) , set the PID parameters, and can move motors with it using the DMC terminal, servo design kit, etc, but when I open Mach3, it says "Galil card not connected".
I only have a Demo copy of Mach. Is that the problem?
Also, on startup it asks which controller to use: "Galil-st-Barker......." or "Galil-Barker......" what does the "ST" extension mean? I downloaded both Galil Mach3 plugins. But what is the difference and which should I use?
In the PDF instructions it says to configure the plugin and there are screenshots of the settings. Where do I find these settings specific to the plugin?
Thanks in advance!