Hello Guest it is May 19, 2019, 02:57:01 AM

Author Topic: Is this possible?  (Read 552 times)

0 Members and 1 Guest are viewing this topic.

Is this possible?
« on: February 28, 2016, 08:04:24 PM »
I am trying to convert an old Amada NC ironworker over to newer controls.   My old controller died a few years ago, but I was able to get it repaired.   It died again, and the company that repaired it has gone out of business.

For the most part the controller is simple.   The hydraulic pump, and a cylinder that goes up and down, a turntable, and the NC locator that moves back and forth.

Is it possible to have a Mach screen that I can enter a length--- say 4 inches, then have the locator move 4 inches, the ironworker punches, then repeat ********* number of times?

What type of controller do I need?   


Thanks


Steve