I've been out in the garage and I've used Feedhold, then Cycle Start 4 or 5 times. I've never had a problem doing it that way. That's generally the way it's intended to work. Once you hit Stop, you usually need to use Run From Here to continue.

That is the way it was intended to work and indeed the way it used to work until a later revision changed it’s behaviour.

Tweakie.

This product is best left in someones garage or basement as a 'toy'....it does not belong in any industrial environment regardless of anyones personal opinion to the contrary.

I think this implies that anyone else’s personal opinion is inferior to your personal opinion which is, of course, quite untrue.
The whole process of forum dwelling is all about sharing knowledge although (as demonstrated in this thread) we certainly don’t all share the same opinion.
As for “toy” software, well I think that if we had a poll you would be out-voted on that one.

Tweakie.

Hey HEY, I 'll argue that point I HAVE made toys with Mach3 . Ask my grandchildren they'll tell ya.

I think we have already had this discussion in an earlier post.

(;-) TP

 

Tweakie.