Hi
Hope this is not a sore subject, I've been reading alot here about limit switches and that long post with Mike, I actually learned quit a bit from everyone's responses. This is not a question about Mach 3 yet as I will set that up after I change this wiring I suspect it was part of my problem before.
I am rewiring my switches from the control box with shielded cable, I have the cable shielding grounded in the control panel and the wires from the pins coming out to a terminal bar. As I start the run to the first limit switch the cable will be grounded these switches will be wired in series switches NC. My question is this, on shielded cable how do I maintain the shielding ground between switches at there different locations, do I splice into the cable to make my switch connection or have a jumper to maintain my ground. I hope I am explaining this right. I am using one pin for my XYZ limits
Thanks Bill