Hello Guest it is March 28, 2024, 06:33:26 AM

Author Topic: Spindle Problems  (Read 1642 times)

0 Members and 1 Guest are viewing this topic.

Spindle Problems
« on: November 22, 2015, 11:11:25 AM »
Mach4, to a PMDX-410, to a G540 to a SuperPID.
The spindle works fine, rpm's are correct.
When I run gcode, the spindle is starting late, meaning the tool is already into the material before it turns on, and it doesn't shut off when I hit the stop or reset buttons. It just goes to the lowest rpm and sits there.

Does Artsoft read these or am I wasting my time posting here??
Meaning is this actual support, or just a user base support?

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: Spindle Problems
« Reply #1 on: November 22, 2015, 11:33:39 AM »
I don't think you will be wasting your time posting anywhere on this forum.

Tweakie.
PEACE
Re: Spindle Problems
« Reply #2 on: November 22, 2015, 11:38:22 PM »
See the PMDX support forums (this question was posted to both forums):

http://www.pmdx.com/PMDX-Forums/index.php?topic=197.0

I'll re-post the final resolution here when we get one.