I have a encoder that only has the pin outs for A and Z but the ENC asks for A,B and I from this should I assume that the encoder needs replacing if so will one with the out puts of A,B and Z fill my needs because this is all I can find and if so will the Z out put be my I. Because I have never used or played with encoders there is little understanding of what is needed for this to work.
As a note this is a Denford lathe and they like to do odd things like with the limit switch's being what they are so I'd not be surprised if I need to replace the encoder
The other one that is doing me is the Inputs to the IP-S for the variable speed control for my inverter what out of +10V, MVI and 0V goes in to what inputs, the over ride pots are working because there was a diagram for me to follow. One thing I have done right or wrong is that my inverter use's 12V to the switching and so I have run 12V from the inverter to the out put's of the IP-S to power it, the inverter will take external 24V supply for the switching but then I need to use the 0V for grounding and until I can understand how I wire in the varibel speed I cant do this because it uses the 0V as a return to the external power supply.
Hope this is readable and some body can help