Hello
Guest
it is
April 24, 2024, 12:57:18 PM
Guest
Login
Register
Menu
Home
Help
Search
Calendar
Members
Members
View the memberlist
Search For Members
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
Estop after turning on spindle
« previous
next »
Print
Pages:
«
1
2
Go Down
Author
Topic: Estop after turning on spindle (Read 3959 times)
0 Members and 1 Guest are viewing this topic.
patton
92
Re: Estop after turning on spindle
«
Reply #10 on:
November 02, 2015, 09:40:53 PM »
bumping the Debounce up is not a fix for the problem it was only meant as a test to see if it's a noise/interference problem. you should go through your wiring and fix the noise by properly grounding and using shielded cable.
Logged
andrew.adsit
3
Estop after turning on spindle
«
Reply #11 on:
November 06, 2015, 04:15:09 PM »
Agree, there are a lot of opportunities to pick up RF. The great cables from the Gecko are compromised at the motor. Need to get that shielding as close to the motor.
Sent from my iPhone using Tapatalk
Logged
Print
Pages:
«
1
2
Go Up
« previous
next »