Hello Guest it is September 20, 2019, 05:08:31 PM

Author Topic: manual z axis  (Read 2044 times)

0 Members and 1 Guest are viewing this topic.

manual z axis
« on: May 05, 2007, 08:44:54 PM »
useing  mach 2 to control plasma table , just hooked up z axis. Can
anyone tell me if you can manual contol the z up and down while a
code is running.. if so how? setting up g code with sheet cam if
that matters...

Hood

*
Re: manual z axis
« Reply #1 on: May 06, 2007, 06:38:47 AM »
I am sure I saw the same question answred a while back, I will do a search and post a link if I find it.
Hood

Hood

*
Re: manual z axis
« Reply #2 on: May 06, 2007, 07:16:16 AM »
Heres the thread I was thinking of, not read it again so it might not be relevant but have a look.
Hood

http://www.artsoftcontrols.com/forum/index.php?topic=2656.0