Hello Guest it is May 29, 2023, 05:35:58 AM

Author Topic: THC Min Speed Button - Documentation?  (Read 2448 times)

0 Members and 1 Guest are viewing this topic.

THC Min Speed Button - Documentation?
« on: September 28, 2015, 12:56:23 AM »
On the Plasma screen there is a button that is labeled "THC Min Speed" with a default value of 60%. What does this button actually do? I noticed that when the button is activated, output 6 on the diagnostic screen flashes even though output 6 is disabled in the ports and pins screen.

Offline Greolt

  •  956 956
    • View Profile
Re: THC Min Speed Button - Documentation?
« Reply #1 on: September 28, 2015, 03:42:28 AM »
THC Min Speed

If your feedrate is set at 100"/min

and CV dictates that feedrate slows down in a corner below 60"/min  (60%)

then Mach will ignore up/down commands from the THC

until feedrate again climbs above 60"/min