Hello Guest it is June 04, 2020, 10:53:39 PM

Author Topic: Slow jogging  (Read 790 times)

0 Members and 1 Guest are viewing this topic.

Slow jogging
« on: August 18, 2015, 12:29:12 PM »
So after years of having this issue, i think i have found the problem. So what is happening is that every time i go to jog, it is running super slow no matter how i change things. I think what is happening is that Mach 3 is not dropping the last feed rate from the previous drill cycle. Has any one had this issue? Any way to flush the feed rate at the end of a program?

Here is the previous discussion about it.