Hello Guest it is March 28, 2024, 06:09:04 PM

Author Topic: need help with artcam post  (Read 2159 times)

0 Members and 1 Guest are viewing this topic.

need help with artcam post
« on: August 02, 2015, 04:52:45 PM »
i'm trying  to make artcam writes plasma codes the point is
how can i make the rapid motions to be in multi lines like
m3
g4 p1
g1 x**** y****   for the feed rate motion
 also
m5
g4 p1
g0 z***
for the safe z

Offline Graham Waterworth

*
  • *
  •  2,668 2,668
  • Yorkshire Dales, England
    • View Profile
Re: need help with artcam post
« Reply #1 on: August 03, 2015, 04:27:55 AM »
This is not the place to be asking that question, you will do much better on the Artcam forum site.

Without engineers the world stops