Hello Guest it is September 27, 2021, 11:47:04 PM

Author Topic: Z axis running in reverse  (Read 6963 times)

0 Members and 1 Guest are viewing this topic.

Z axis running in reverse
« on: July 26, 2015, 08:41:37 PM »
Need some help if you please. I am attempting to run my first project on Mach 3 and when my router begins to run it slams into my table. (Good thing I have a spoil board) I have narrowed the issue down to the Z axis being programmed in reverse but am unsure how to correct it.
 Help please...
Caution: Do not reach into running equipment

Offline Tweakie.CNC

  • *
  •  8,807 8,807
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Z axis running in reverse
« Reply #1 on: July 27, 2015, 03:44:47 AM »
If you have your machine Z axis direction wrongly set then...

Config / Ports & Pins / Motor Outputs - change the 'Dir Low Active' state for your Z axis (cross or tick) then click Apply.

That will change the Z axis direction.