Hello Guest it is May 14, 2021, 02:25:17 AM

Author Topic: Spindle turn of mach  (Read 1943 times)

0 Members and 1 Guest are viewing this topic.

Offline amnon

*
  •  40 40
    • View Profile
Spindle turn of mach
« on: July 04, 2015, 01:01:12 PM »
Hej,

Why is that, when program runs with M3(spindle on), after a few minutes Mach suddenly stop and Reset button is red. It doesn't happen when spindle is off. Is it cause by line interference?

Best Regards
Amnon
Re: Spindle turn of mach
« Reply #1 on: July 04, 2015, 01:12:59 PM »
If you have a VFD driven spindle or a spindle motor with brushes, the chances
are good that there is enough electrical interference to cause the problems
that you are seeing.
Steve Stallings
www.PMDX.com
For PMDX product support, please use PMDX forum or direct email for quickest response. We do not use this forum as our primary product support site.

Offline amnon

*
  •  40 40
    • View Profile
Re: Spindle turn of mach
« Reply #2 on: July 20, 2015, 09:09:56 AM »
I've instaled interference eliminator, but still nothing. Kress stop all the time when start cutting. What can I do more?
May Relay have something to say, I mean if is not big enough?

Respect
Amnon
Re: Spindle turn of mach
« Reply #3 on: July 20, 2015, 10:44:34 PM »
Tell us more about your system, what version of Mach, what hardware interface?

Where did you install the filter?

What message is in the status line at the bottom of the screen when Mach stops?
Steve Stallings
www.PMDX.com
For PMDX product support, please use PMDX forum or direct email for quickest response. We do not use this forum as our primary product support site.

Offline amnon

*
  •  40 40
    • View Profile
Re: Spindle turn of mach
« Reply #4 on: July 22, 2015, 10:03:58 AM »
Done - additional filter

Thank's