Hey Guys

Im Brand new to the Forum. And I'm need of a bit of information.
I have bought a Chinese router and I'm struggling to get Mach3 to communicate with the Motion Card. I'm Getting the 8877 message as well. I have been on the manufactures of the Breakout board website and downloaded the driver from there as i was hoping it was a problem with the one supplied from china. but still same error message.
Can anyone point me in the direction of a driver they know works? Or shed some light on things?

Thank you very much

Nick

is the copy of Mach 3 registered to you or did it come with the machine

Daniellyall Thanks for your reply

is the copy of Mach 3 registered to you or did it come with the machine

The software came with the machine. It is only running in demo mode. I was hoping to test machine before licensing. If it won't run on demo mode i guess il purchase now. 
I have downloaded the latest demo of mach3 but still the same problem.

Cheers
Nick

I am not sure what it is it has come up a few time have you looked back through the forum

I am not sure what it is it has come up a few time have you looked back through the forum

Yeh i have found a bit of information. Most info i have found would suggest bad drivers. The gentlemen on this posting has replaced the drivers and solved the problem. Figures crossed.

Nick