I am creating a automated machine to help in the production of some lights we manufacture. I am using Mach 3 to control a 3 axis table but i am having trouble getting the axis to run smoothly when i run actual g-code. I have tuned the motors using the suggest motor tuning in Mach 3 and they work perfectly when i just manually move the all axis's. Has any one ever seen this issue before. I must admit i am not the most experienced at this stuff!
My machine hardware
Drivers: DM524 on all axis
Controller: USB XHC 6 axis made by cdhctech.com
Steppers: 23HS2430B 1.8 Deg 3 Amp
I have Steps per at 80, velocity at 2500 and Acc. at 750
Thanks
Scott