Hello Guest it is December 03, 2024, 04:26:38 AM

Author Topic: Rotary axis positioning problem  (Read 1801 times)

0 Members and 1 Guest are viewing this topic.

Rotary axis positioning problem
« on: April 27, 2015, 11:17:02 AM »
I have a rotary axis controlled via a 320 gecko DC drive. I can tune it to give within a half degree accuracy on 3600 degrees rotation ( Ten rotations ). I can repeat this several times in one direction. When I command it to travel the other direction it is off by about 40 degrees ? There is less than 1/4 degree backlash in the gearing. Any ideas on where the problem would be ?

Thanks,
Scott