Hello Guest it is July 21, 2019, 09:36:29 AM

Author Topic: New Mach3 download and now my table won't run.  (Read 1112 times)

0 Members and 1 Guest are viewing this topic.

New Mach3 download and now my table won't run.
« on: January 28, 2015, 04:23:50 PM »
I recently replaced my PC and had to download the Mach3 again. I also added the gecko program for the g540. My table will not run. The motors are activated and in the hold state. The X, Y and Z indicators in the Mach3 program run show the hot keys are functional and moving correctly. However still no table moves. Am I missing something in the config?
Re: New Mach3 download and now my table won't run.
« Reply #1 on: January 29, 2015, 12:16:40 PM »
Resolved. The Mach 3 driver was missing. Cloned old hard drive and it is back up and running once again.