Thanks.
I gave it a try but it seems that the USB board is not up to the task from what I gather.
From what you guys are saying is that the command comes from Mach3 to the USB breakout board.
Then the USB board is what actually directs the motor control units to carry out the process.
I guess I will need to swap out the board to something better. Now BR549 suggested the Smoothstepper ESS.
Has anybody swapped this over to the China unit? If so, is there a thread with some good step by step info on it.
Below is the video of what it does with the modified Z1.1000 code.
I have also noticed there is a line jump when the code starts.
The changing of the code did not seem to work out. So I must be led down the path of the board swap.
The motor controls are a YOOCNC model YOC335. Will the Smoothstepper ESS work with these controllers?
And for anybody that has this we were thinking it was a number 0 when in fact they turned out to be a letter O.
https://www.youtube.com/watch?v=7cLjqkz2du8&list=UU1yUgVGBJKdrfs3Bift3LEA