Hi, I'm having trouble setting up homing switches.
I have NC switches on X, Y and Z connected in series to pin 11
I have a NC switch on B (axis is slaved to X) connected to pin 10, "Home Slave with Master axis" is unchecked
There are no other inputs connected or configured.
On the diagnostic page, with axis away from home switches, LEDs for Pin 10 and 11 are unlit and none of the Home LED's are lit. When I press the switch on x, y or Z the LED for pin 11 lights, along with M1, M2, M3 home LEDs. When I press the switch for B, LED for 10 and M5 home LED lights.
All going to plan so far....
When I press the REF ALL HOME button, each axis motor jogs a few steps and stops. one of the LED's for the input pins or homing indicators illuminate The LEDS on the Zero X , Y and Z buttons change from Red to green and the machine co-ord set to zero as expected, but they are no where near the switches. Pressing again just repeats the motion.
The same happens when I try the individual axis on the diagnostic page.
Does anyone have an idea why I cant Ref Home?
Thanks in advance
Jon