Hello Guest it is September 24, 2023, 02:28:59 AM

Author Topic: Why does my slave axis do this?  (Read 4949 times)

0 Members and 1 Guest are viewing this topic.

Re: Why does my slave axis do this?
« Reply #10 on: December 21, 2014, 06:30:22 PM »
So, I'm trying to figure out what's up and I may be stumbling upon something just not sure what....

When I powered up this morning I noticed that the Machine co-ordinates for X and Y were both 0,0 and the gantry was no where near X and Y 0,0. So, I started looking at the home and limits settings and didn't notice anything strange. I tested all the Home switches and they all work accordingly and I also pulled the control panel thinking maybe a lose wire but nothing.

I then checked the soft limits button since it didn't make sense why the machine thought it was at 0,0 and I'm not sure what happened but things are working again, I must have missed a button click or something..ugh!!???

So here's a video using the default "Ref Al Home" after the miracle fix and it works repeatedly without issue..