Hello Guest it is April 17, 2024, 08:04:34 PM
Profile Guest
« previous next »
Pages: « 1 2 3   Go Down

Author Topic: Problem with MACH3 and first peck drill cycle  (Read 13756 times)

0 Members and 1 Guest are viewing this topic.

Offline rcaffin

*
  • 1,054 1,054
    • View Profile
Re: Problem with MACH3 and first peck drill cycle
« Reply #20 on: March 31, 2018, 08:11:06 PM »
There are some things I do not meddle with, and feed&spin at boot time is one of them. Yes, we KNOW there are some bugs in Mach3, including this area. We just avoid them.

Cheers
Roger
Logged

Offline Davek0974

*
  • 2,606 2,606
    • View Profile
Re: Problem with MACH3 and first peck drill cycle
« Reply #21 on: April 01, 2018, 03:31:02 AM »
Yes, feed-rate override is dodgy as hell, I'm on v066 ;)

Its ok for a slight tweak while running but i always return it to 100% at shutdown.

Its not so bad <100% but not good >100%
Logged

Offline bondeoca

*
  • 20 20
    • View Profile
Re: Problem with MACH3 and first peck drill cycle
« Reply #22 on: April 01, 2018, 08:36:58 AM »
 Just to make sure we are on the same page , I am talking about reducing the Rapid feed rate , not the commanded feed rate for the drill cycle .
Logged

Offline Davek0974

*
  • 2,606 2,606
    • View Profile
Re: Problem with MACH3 and first peck drill cycle
« Reply #23 on: April 01, 2018, 08:38:09 AM »
How are you reducing it??
Logged

Offline bondeoca

*
  • 20 20
    • View Profile
Re: Problem with MACH3 and first peck drill cycle
« Reply #24 on: April 01, 2018, 08:41:37 AM »
 On the settings page. Rapid OR box.

Rick.
Logged
Pages: « 1 2 3   Go Up
« previous next »