Hello Guest it is March 28, 2024, 12:44:53 PM

Author Topic: BOB jumpers  (Read 2870 times)

0 Members and 1 Guest are viewing this topic.

BOB jumpers
« on: September 24, 2014, 11:52:24 PM »
Hi,I'm having trouble with the limit/home switches on my CNC home built,purchased a full licence for Mach ,have Geko g203v stepper drivers all was going well steppers drive, wired the Limit/Home switches so that if a wire is broken It should stop the machine,.After 4 weeks on and off trying to set the jumpers I am at a loss on how to set the board  to see the limit/ home switches in Mach .I have a Homann MB -02-V6 breakout board ,Hoping that some one may be able to shed some light on how I do this having already mastered this board ,i would be most grateful .
BOB jumpers
« Reply #1 on: September 26, 2014, 10:54:20 AM »
Can you please tell us in what locations you have them hooked up. A picture would help tell the story also. I have 3 of this model of Bob from Peter. They work very well. Have had them working well with pp/usb ss/Ess.


Alan
Re: BOB jumpers
« Reply #2 on: September 26, 2014, 03:58:05 PM »
Hi, Yes used the schematic on his website EN-012 only change is a power supply doubler for the 2 power supplies running 4 steppers.here is a pic of the jumpers at the moment.
Re: BOB jumpers
« Reply #3 on: October 12, 2014, 05:12:31 AM »
She still is a pain I wonder if the BOB is the issue.?

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: BOB jumpers
« Reply #4 on: October 12, 2014, 06:36:01 AM »
Have you emailed Peter to ask if he can help?
Hood
Re: BOB jumpers
« Reply #5 on: October 12, 2014, 03:23:08 PM »
Yes I sent a couple but I did not hear so went over to the other forum I think it may  be the board it cant be this hard 6 weeks :)

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: BOB jumpers
« Reply #6 on: October 18, 2014, 06:03:31 AM »
Usually Peter responds, might be worth sending him a private message flagging this post.
Hood