Hello Guest it is September 25, 2023, 11:19:50 AM

Author Topic: On input signal estop?  (Read 1769 times)

0 Members and 1 Guest are viewing this topic.

On input signal estop?
« on: August 25, 2014, 03:34:51 PM »
I have servo drivers who gives High signal on servo failure.
I have added that signal as input1 in Mach3.
Now I don't know how to configure Mach3 to go to estop when input High,
and maybe to display "servo failure". Just maybe.
Any help would be nice.
Thanks, Ivan

Offline Hood

  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: On input signal estop?
« Reply #1 on: August 27, 2014, 05:43:43 AM »
There is a check box on General Config page to make Mach sop on Input1 signal.
To do the message part you could use a Brain or the macropump to inform you.

Personally I would use the macropump and have it also E-Stop Mach when Input 1 is seen.