Ok, I have the Y axis motors labeled YR and YL
No matter what is do, the YR stepper is always behind the YL
I can switch Gecko 202's, leads,pins in Mach3, ect and always the actual YR motor always is behind the YL...
For instance, after 5 revolutions of the YL...the YR is about 90 degrees behind the YL
No matter what is change in Pins, Geckos, outputs from the Breakout Board...
The actual YR motor trails the YL ....
Thus, I cannot see how it could be anything other than the YR stepper being bad...
Does this make since???
Thanks Hood!!!