When I try to load Mach 3 after installing the Galil ST plugin.  I get a message saying that the plugin .DLL is not valid.  I have downloaded and installed a few times with no change.  I have also tried this on 2 separate computers, one with Win 7 and the other with XP.
However, if I install the Galil plugin for the older Galil software then Mach 3 accepts it.
Is there a known issue with the ST plugin?  If so is there a workaround?

Best to ask on the Galil section of the forum.
Hood

I did but got no response.
Correction;  I thought that I had but maybe I did it in a plugin thread.

Try sending a PM to Steve (Smurph)

Hood

Thanks, I'll try that.