Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: tonyfoale on June 25, 2014, 04:09:20 AM
-
When I try to load Mach 3 after installing the Galil ST plugin. I get a message saying that the plugin .DLL is not valid. I have downloaded and installed a few times with no change. I have also tried this on 2 separate computers, one with Win 7 and the other with XP.
However, if I install the Galil plugin for the older Galil software then Mach 3 accepts it.
Is there a known issue with the ST plugin? If so is there a workaround?
-
Best to ask on the Galil section of the forum.
Hood
-
I did but got no response.
Correction; I thought that I had but maybe I did it in a plugin thread.
-
Try sending a PM to Steve (Smurph)
Hood
-
Thanks, I'll try that.