I have a mill that I just bought and need to get the limit switch config fixed. When I bought the machine they worked . Now that I got it home and had to swap out computers and install mach 3  and load old settings the limit switch config is not correct I have the mill running just need the limits so I can home out the machine.
any and all help is appreciated

Either trace out the wiring so you can see which port/pin the switches come into Mach or you could use the auto input setup in Ports and Pins, Inputs .
Hood

I'll look for the auto and see if that works

I can now home out thanks now I have to read up on what the other limits are kinda confusing since their are X- and X--

There are not X- and X--.
You have X+ and X- limits, that's it. They're labeled X++ and X-- in Ports and Pins.

Ok gotcha

So quick question. X++ is the table moving x+ or is it the table going left as it is cutting x+

my last post I wasn't thinking lol and looked again and noticed that your correct.



there is
X++
X-
X home

So quick question. X++ is the table moving x+ or is it the table going left as it is cutting x+

my last post I wasn't thinking lol and looked again and noticed that your correct.



there is
X++
X--
X home

fixed type o