OK, I got it now. I renamed the 1024.Lset to 1024.lset. Not sure if the capital "L" was a problem or not. Anyway, I now have lathe driver in a mill window.
It even states that at the bottom of the screen, "New driver installed" "Lathe". Even the work progress widow looks like it is making a lathe part.
However, I'm still having trouble machining a radius on the end of the workpiece. My code works fine in Mach3Turn but not in LATHE.
Here is the code:
G01 Z0.00 {TOOL AT END OF WORKPIECE}
G01 X0.00 {TOOL AT CENTER}
G02 X.325 Z-.16 R.16 {TURN .16 RADIUS FROM END CENTER TO X.325 Z-.16}
What it does. Starts at the end and center of workpiece. Swings an arc away from the workpiece in the Z+ direction then back to the workpiece. It swings an arc but never touches the workpiece. I also tried R-.16
I'll bet I need to switch it from radius mode to diameter mode or something. If so how?
Almost there.
Thanks, Jim