///////////////Configuration Check Facility///////////////////////
Any obvious errors are checked by this facility, passing does not mean
you have no errors, but as more error possibilities are found,
more checks will be added to this facility.
Currently, the most frequenct tech-support errors are checked for.
///////////////LIMIT & HOMING CHECK///////////////////////
No Errors Found!
////////////////////// End of Homing and Limits Check ///////////////////////////////////
///////////////OUTPUT Signals Check///////////////////////
No port/pin errors found in output signals.
///////////////End of OUTPUT Signals Check///////////////////////
//////////////// Digitising Probe /////////////////////////
/////////End of Probe Check /////////////////////!.
/////////Motor Settings - Enabled Motors only are Checked/////////////////////!.
A motor Step pin is set to a port other than 1 or 2, this is probably an error..
A motor Direction pin is set to a port other than 1 or 2, this is probably an error..
/////////Motor Settings - End of Motor Checks/////////////////////!.
Checkup complete , please check any errors listed.
Thank you for checking your Settings.....
------------------------------
My config file