Moved the discussion from "General forum" to here.

I set  an 8x8 input matrix, and assign some for JOG XYZ, (One key for X+ another for X- etc)
Following is observed:
- Continues JOG is selected
- Pres_and_hold a button: Causes axis to JOG, Release = Stop.

If I then toggle the JOG to OFF, the I cannot JOG on the regular PC-Keyboard, but
When I Press and release a key via my PoKeys input matrix, the Axis starts and Continues to JOG, untill "Stop" or "E-stop" is activated ?!
(This is valid for all axis in both directions)

If I select MPG-mode (Instead of continues) and THEN toggle JOG = Off then it's all good, nothing moves, just as I expected the JOG = Off function to work ?

(Further I have some issues with the formatting of DRO in the LCD, but I'm not sure if bug-reports are in this forum ?)
Best Regards, Bo Andersen.

Hi, Bo

Please forward all bug reports to matevz@poscope.com.

We will check the jogging issue. Which PoKeys version has been installed? And most importantly - is PoKeys device being used as a motion device or only as an interface?

Regards,
Matevž