ok, its possibly because I am total newb to Machining. but let me ask you this question this way.
Ok, so my Mill is an X2, which really means that my table moves.
so, If I draw a box in BobCad, then put a pocket in it.
So based on my code
Its my understanding, that the table will move in what ever direction it takes, to put the bit at B1, then Cut to A1, then move down a bit to A2, then cut till it reaches B2 , then move down, and so on and so on till it reaches D 8.
A B
1 *********************************************************************************X 1
2 *********************************************************************************X 2
3 ********* XX 3
4 ********* XX 4
5 ********* XX 5
6 ********* XX 6
7 *********************************************************************************X 7
8 *********************************************************************************X 8
C D
is this a fair representation of whats going to happen?