Hello Guest it is November 24, 2020, 12:56:19 PM

Author Topic: Upgrading question 32bit vs 64bit, USB vs Parallel , Mach 3 vs Mach4 HELP!  (Read 15876 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,846 25,846
  • Carnoustie, Scotland
    • View Profile
Re: Upgrading question 32bit vs 64bit, USB vs Parallel , Mach 3 vs Mach4 HELP!
« Reply #10 on: January 20, 2014, 07:11:00 PM »
I am sure I will remember from now on ;)

Hood
Re: Upgrading question 32bit vs 64bit, USB vs Parallel , Mach 3 vs Mach4 HELP!
« Reply #11 on: January 20, 2014, 07:41:53 PM »
going to assume you have never seen this either? g0704.com

Offline comet

*
  •  318 318
    • View Profile
Re: Upgrading question 32bit vs 64bit, USB vs Parallel , Mach 3 vs Mach4 HELP!
« Reply #12 on: January 22, 2014, 12:55:01 PM »
I use a uc300 usb controller from cncdrives there very very good and reasonably priced